Avanti ER20P0W, Instruction Manual

Page: 10 / 40

10
INSTALLATION INSTRUCTIONS
IMPORTANT – SAVE FOR THE LOCAL ELECTRICAL INSPECTOR’S USE.

BEFORE USING YOUR ELECTRIC RANGE
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the following parts:
•
3 Six Inch Coiled Burners with Reflector Bowls(Pre-installed)
•
1 Eight Inch Coiled Burner with Reflector Bowls(Pre-installed)
•
2 Oven Racks
•
1 Broiler Tray and Grid
1
Anti-tip Bracket
(Packed in the Styrofoam packing above the range – DO NOT DISCARD)
•
1 Instruction Manual
•
1 Backsplash Assembly (Backsplash and (5) five screws)
(Packed in the Styrofoam packing above the range – DO NOT DISCARD)
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Have your range installed and properly grounded by a qualified installer in accordance with
the installation instructions.
•
Do not attempt to repair or replace any part of your range unless it is specifically
recommended in this manual.
•
Do not remove permanently affixed labels, warnings, or plates from the product. This may
void the warranty.
•
The installer should leave these instructions with the consumer who should retain for local
inspector’s use and for future reference.
•
Please observe all local and national codes and ordinances.
IMPORTANT:
This range is designed and manufactured solely for the cooking of domestic (household) food and
is not suitable for any non-domestic application and therefore should not be used in a commercial
environment.
The range warranty will be void if the range is used within a non-domestic environment i.e. a semi
commercial, commercial or communal environment.
NOTICE
Before you use this range for the first time : The heating elements have a protective
coating, which must be burned off before use. To do this, open the oven door and set the
temperature control knob to 450°F. Turn the function selector to the Bake element and the
Broil element separately to approximately 15 minutes. It is important to ensure adequate
ventilation during this period.
The burners also have a protective coating, which must be burned off before use. To do this,
set the burner selector to the maximum setting 5 minutes. It is important to ensure adequate
ventilation. Switch off the burners and allow cooling completely.
WARNING
HAVE THIS RANGE INSTALLED BY A QUALIFIED INSTALLER.
Improper installation, adjustment, alteration, or maintenance can cause injury or property damage.
Consult a qualified installer, or service agency.