DIGITAL TRANSDUCER TESTER & PC-INTERFACE (AVA-03)
14-FEB-2022
PAGE 11 OF
12
© Avanti Elektronik Limited - (44) 01224-583132 - www.avanti.clara.net - [email protected] dqdtst_32.docx
8. THIRD PARTY LOGGING/CHARTING SOFTWARE
As described above, all RS232 commands and responses contain only ASCII characters,
allowing full access with standard terminal software like Hyperterminal. For basic data
logging the AVA-03 can be put into continuous output mode with the "CM" command.
If more complex data logging or display/charting functions are required, there is a low-cost
3rd-party software available that runs on Windows PCs (see www.windmill.co.uk).
Windmill-7 data logging software includes a user configurable parser that can be set up to
suit the AVA-03 command set. Setup can be a bit tricky, but once configured the software
is easy to use. Please note however, that this is 3rd-party software and beyond control of
Avanti Elektronik Ltd. No guarantee can be given regarding its suitability and no support
will be provided.
Below are some screenshots obtained with Windmill-7 software.
Figure 3: Windmill Data Display Panels showing 2 Transducers (A and B).
Figure 4: Windmill Charting Module displaying 2 Pressures (A and B)
