- 4 -
User Manual
Installation
Please read this manual thoroughly prior to equipment setup, operation and maintenance.
Important!! Please Read Before Installation
• If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to
promote proper air flow. Failure to install the shelves properly is considered user-error and is not
covered by warranty.
• If the unit has recently been transported on it’s side, please let the unit stand upright for a
minimum of 24 hours before plugging it in.
• Make sure the unit has reached the desired temperature before loading the unit with products.
• Make sure all accessories are installed (shelves, shelf clips, etc.) before plugging in the unit.
• Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing/repairs.
• Do not hang on doors or stand inside the unit.
• Do not store flammable, explosive, or corrosive liquids or gas in or near the cooler.
• Please read through this manual in its entirety.
Cabinet Location Guides
• Install the unit on a strong and leveled surface.
- If the surface is uneven, the unit may be noisy or malfunction.
• Install the unit in a well-ventilated, indoor area.
- For best performance, maintain 4” of clearance on both sides and the back of the unit
at all times.
- Outdoor use may cause decreased efficiency or damage to the unit.
- Avoid direct sunlight.
• Avoid installation in a high humidity and/or dusty area.
- High humidity can cause the unit to rust and may decrease efficiency.
- Dust collected on the condenser coil may cause unit to malfunction.
- Malfunction do to high ambient temperatures, humidity, or improperly maintained
condenser coil will void the warranty.
• Select a location away from heat and moisture-generating equipment.
- High ambient temperatures may cause the compressor to malfunction.
- Malfunction due to high ambient temperatures and humidity will void the warranty.
- Moisture may cause rust to form on the compartment body which could affect the electrical
insulation.
