User Manual
6 www.AvantcoEquipment.com
Installation of Your Steamer
1. QuickShot QS-1800 is 120V, 1800W and uses a 5-15P NEMA plug.
2. All electrical connections must comply with specifications and power standards. The installation must be done by
qualified personnel.
3. All models are countertop type. Remove all exterior and interior packing materials, and place the steamer on a flat
surface.
4. Place near an appropriate electrical outlet. Extension cords are not recommended.
5. Install legs onto unit.
Before Using Your Steamer
Before steaming anything in your steamer for the first time, please follow these simple instructions:
1. Using a small amount of detergent, thoroughly wash the steamer.
NOTE:
Do not use a spray or abrasive polishing agent.
2. Gently wipe down the interior walls with a damp cloth.
Using Your Steamer
1. Plug unit into a grounded outlet.
2. Open tank cover. Ensure filter is properly installed inside.
3. Fill unit with approximately 3 qt. of cold tap water. To reduce calcium/mineral build-up, use distilled water. Do not
overfill.
4. Flip the on/off switch to the ‘on’ position. Allow the unit to preheat for 25 minutes.
5. Open top cover, and load product into the basket or half size perforated food pan. Close top cover.
6. Press steam button for 2 seconds. Release, and wait 20 seconds for steam to penetrate the product. Repeat as
needed. Avoid pressing and holding the steam button for longer than 2 seconds, as it often floods out and hinders
proper steaming.
7. Remove hot product from steamer.
8. Flip the on/off switch to the ‘off’ position.
CAUTION: Foods steamed in this unit will be hot. Wear protective hand coverings when reaching into steamer to
retrieve food.
