6(10)
5.1.
Assembling the spreader
Fitting the wheels:
The wheels (1) must be set on the shaft so
that their filling valves are on the inner side
of the wheel. The correct orientation of the
wheels must be observed because of the
clutches welded on the wheel rims, so that
the spreader will work correctly; rotating
the doser shaft when driving forward, and
allowing the wheels to rotate freely when
reversing. The wheel is locked to the shaft
(2) with locking pin (3). The nut of the
clutch locking pin must be tightened so that
the clutch will operate smoothly.
Installing the drawbar:
To install the drawbar, first a support
bracket (1) is fitted to the spreader with two
bolts as shown in figure 2. Then the
drawbar (2) is fitted to the spreader with
three bolts and to the support bracket (1)
with one bolt and nut.
Fitting the doser adjustment bolt:
After fitting the drawbar, make sure that
the doser adjustment plate (1) can move
unobstructed. If necessary, adjust its fitting
bolts (2).
Then the doser adjustment bolt (3) and its
spring (4) can be fitted. Before using the
spreader, make sure that the adjustment
bolt is not tightened too much, as
overtightening may cause the sand to drain
from the spreader.
4
3
2
1
Figure 1 – Installing the wheels
1
2
Figure 2 – Installing drawbar
2
2
1
3
4
Figure 3 – Doser adjustment bolt
Summary of Contents for 415430
Page 10: ......
