17
300S Series
Coupling the attachments
COUPLING THE ATTACHMENTS
Coupling of the attachments into the attachment coupling plate happens as follows:
Stage 1:
Lift up the two locking pins on either side of the attachment
coupling plate and turn them backward so that they remain
in the locked up position
Make sure that the pins remain in the up position, otherwise
you cannot couple the attachment properly!
Stage 2:
Turn the attachment coupling plate with the tilt movement
so that the upper edge of the plate leans forward.
Drive the loader into the attachment
Stage 3:
Lift the boom a little so that the attachment lifts off of the
ground
Pull the boom control lever to the left so that the lower edge
of the attachment coupling plate turns into the attachment
Stage 4:
Pull the boom control lever more to the left so that attachment
coupling plate turns more and the bolts on the boom push
the pins down in the holes of the attachment.
CAUTION! Make sure that the pins lock properly
down in the holes of the attachment.
Stage 5:
Coupling the multi connector
Align the pins of the attachment connector with correspondig
holes of the loader connector. Connecting is not possible if
the multi connector for some reason is mounted in a wrong
way on the attachment hoses. Connect and lock the
multiconnector by turning the lever towards the loader.
Disconnect attachment hoses by pressing on the red button
on the multiconnector and simultaneously turn the lever
away from the machine.
