Avalue Technology EBM-A50M, User Manual, Page: 20 / 79

EBM-A50M User
’s Manual
20 EBM-A50M User
‟s Manual
2.3 Jumper and Connector List
You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the board
‟s jumpers and connectors.
Jumpers
Label Function Note
JBAT Clear CMOS
3 x 1 header, pitch 2.0mm
JHS Handset speaker Mode selector (Optional) 3 x 2 header, pitch 2.0mm
JP1 Serial port 1
–RS-232/ 422/ 485 selector
4 x 3 header, pitch 2.0mm
JP2 Serial port 2
–RS-232/ 422/ 485 selector
4 x 3 header, pitch 2.0mm
JP3 SATA 1 Pin 7 Power Mode selector 3 x 1 header, pitch 2.0mm
JP4 SATA 2 Pin 7 Power Mode selector 3 x 1 header, pitch 2.0mm
JRI1 Serial port 1 pin9 signal selector
3 x 2 header, pitch 2.0mm
JRI2 Serial port 2 pin9 signal selector
3 x 2 header, pitch 2.0mm
JVR
LCD backlight brightness adjustment 3 x 2 header, pitch 2.0mm
SW1 Multi-function select DIP switch 6pin
SW2
Serial port 1/ 2
– RS232/ 422/ 485 mode
selector
DIP switch 6pin