Contact us for assistance: (866) 985-7877 | www.wtliving.com
4
aSSeMbLY
1
Assemble the base: you will need both Leg Frames
A
and
both Tabletop Supports
B
. Attach one Tabletop Support
to a corner of the first Leg Frame using 1 Screw
E
. Check
that the three drilled holes face up and down, not toward
the sides. Tighten using your Screwdriver. Repeat to attach
the other Tabletop Support to the other corner.
Locate the holes drilled on the inside of each Frame along
one side (see enlargements) and ensure that the drilled
sides are aligned as shown. Attach the second Leg Frame
to the opposite ends of the Tabletop Supports as before
and tighten.
2
Join the base to the tabletop: Place the Tabletop
D
upside-down (drilled holes should face UP) on a soft,
level surface. Align the drilled holes in the Tabletop
Supports with the holes in the underside of the Tabletop.
Using 6 Screws
E
, fasten the pieces together as shown.
3
Brace the base: align the hole in each end of the Metal X
Brace
C
with the pre-drilled holes in the Leg Frames.
Insert a Screw
F
through each hole into and through the
Leg Frame. Fasten using a Screw Cap
G
on the end of each
Screw.
Tighten with the Wrench
H
.
Check all hardware for
tightness, then carefully turn the desk upright.
Your Tribeca Studio Desk is ready to use!
You will need a Phillips Head Screwdriver for assembly.
Hardware Used:
E
M 6x30 Screw x 4
Hardware Used:
E
M 6x30 Screw x 6
Hardware Used:
F
M
4x27mm
Screw x
4
G
Screw Cap x 4
