Optional Equipment
3 5
Travis Industries
4 0 6 0 2 1 0
9 3 5 0 8 0 7 5
Optional Log (Part # 98900126)
!
Make sure the heater has fully cooled before installation.
1
Assemble the log shelf following the directions below.
Right Log Shelf Leg
Left Log Shelf Leg
Log Shelf Cross Brace
3/8" Nutdriver
Nuts
2
Remove the firepot from the pellet stove. Center the log shelf
assembly (with extender attached) over the burnpot holder. Replace
the burnpot. Place the log on the log shelf extender. When in place,
the log should appear as shown in the photograph to the right.
Center the log on the log shelf and
push it back so it rests against
these two tabs.
Place the log shelf assembly so the
back edge contacts the cast firebrick
in the rear of the firebox. Note how
the taper on the assembly matches
the taper on the cast firebrick.
a
b
NOTE:
On inserts, the ash box must be
installed before placing the log shelf
assembly.
Optional Gold Door (part # 99300531)
Remove the door by sliding it up
and off the door frame.
Slide the new door onto the door
frame.
HINT: align the bottom joggle
clips over the brackets on the
door and slide into place. Then
lift up slightly on the door to
attach the upper clip.
The door is held in place with 4
joggle clips.
Door
Frame
Door
Summary of Contents for Avanti PI
Page 2: ......
