The following are the steps necessary to install the LineAR mount on a T-Pod tripod:
Rotate the mount
a
zimuth knobs of a few turns
to make enough space for the insertion of the
tripod brass contrast block.
Put the mount on the tripod plate, so that the
mount bottom plate will fit perfectly with it
and the brass contrast block is in between the
two azimuth screws. The mount body will
remain well balanced over the tripod.
Tighten the two fixing screws equipped with
plastic knobs in the two elongated holes to
maintain the mount firmly in position.
Rotate the azimuth knobs until they touch the
contrast block.
Note:
During the azimuth regulation for polar
alignment, these three screws must be slightly
loosened just enough to allow the mount to
rotate on the base.
When the polar alignment
is reached tighten the screws again.
©
All Rights reserved
12
Summary of Contents for Linear Fast Reverse
Page 3: ...All Rights reserved 3...
