AW900XTP
User’s Manual
PAGE 4
Technical support
(650) 384-0000
www.avalanwireless.com
Physical Setup
1. Before mounting the radio in its final location, you may want to perform the
digital setup procedure described in the next section.
2. Mount the AW900XTP securely using the mounting bracket provided or other
means as necessary. Maximize lightning resistance by providing a strong DC ground
connection to the metal housing.
3. The unit may be mounted with horizontal or vertical polarization and it is impor-
tant that the antenna of the Access Point and the antenna of the Subscriber Unit be
pointed toward one another and be oriented with the same polarization. In a point-
to-multipoint situation with radially dispersed SUs, you should use an AW900XTR
equipped with an omnidirectional antenna as the Access Point
4. Power is provided to the unit by means of the Ethernet cable, allowing the power
supply to be located at a convenient location. The included power-over-Ethernet
injector (POE) provides the means for adding DC power to unused wires in the cable.
Decide where to place the POE based on proximity to AC power at some point along
the desired path of the Ethernet cable. Plug the included power supply into an ap-
propriate electrical outlet and into the POE. Connect an Ethernet cable between
your network and the “DATA IN” port on the POE. Connect a second cable from the
“P + DATA OUT” port on the POE and the AW900XTP. The AW900XTP is provided with
a cable clamping device that allows an RJ45 plug on the cable to pass through it and
can be tightened down around the cable to provide a weatherproof seal.
Digital Setup
1. Digital configuration is done by means of the AW900XTP’s built in browser in
-
terface. It should be powered on and connected at least temporarily to a network
containing a computer that can run a conventional web browser.
2. Download the AvaLAN IP Discovery Utility from our website and extract
ipfinder.exe from the zip archive, placing it on your desktop or in a convenient
folder.
http://www.avalanwireless.com/ipfinder/ipfinder.zip
Note that this utility only runs on MS Windows, not linux or MAC. If you must use a
non-Windows computer for configuration, make sure your subnet mask allows your
computer to see 192.168.17.17. Connect to that default IP address with your web
browser, continuing the setup procedure with step 6.
3. Run the IP Discovery Utility, ipfinder.exe and you should see a window similar to
the view on the next page.
