TECHNICAL SUPPORT
For assistance installing, configuring, or running
the HBA, contact Avago Technical Support:
WARRANTY NOTICE
1.
Warranty does not cover the return of parts
damaged by changing the bracket.
2.
Warranty does not cover ESD damage to the
HBA. HBAs returned without a bracket mounted
on the board will be returned without return
merchandise authorization (RMA) processing.
Web Site:
www.avagotech.com
Avago Technologies and the A logo are trademarks of Avago Technologies in the United States and other countries. pub-00509
0
. All other brand
and product names may be trademarks of their respective companies.
Corporate Headquarters
Website
www.avagotech.com
Pub Number: 5972-4857-P0
Copyright © 201
6
Avago Technologies
All Rights Reserved. January 8, 2016.
Figure 3. Heat Sink Held in Place by Retaining Clips Attached by Bracket Screws
CAUTION:
Do not move or rock the heat sink after you remove the bracket screws. Doing so
might damage the thermal interface material, which causes the board to overheat
during operation. Damage to the heat sink or the interface material while changing
the bracket might void the board warranty.
4.
Place the controller on top of the replacement bracket.
Place the RAID controller on top of the
replacement bracket. Make sure to position the bracket so that the screw holes in the tabs are aligned
with the openings in the board as shown in the following figure.
Figure 4. Replacing the Bracket
5.
Use an ESD-safe #1 Phillips torque screwdriver to set the screws to a maximum torque of 4.8
± 0.5 inch-pounds to replace the two Phillips screws that you removed in step 2.
6.
Replace the board in its ESD-protective bag, and seal the bag appropriately.
ATTENTION:
Exceeding this torque specification can damage the board, connectors, or screws, and can
void the warranty on the board.
