Auvon AS8012, Manual

Page: 21 / 186

17
Support@iauvon.com
OPERATING PROCEDURES
HOW TO USE
1. Clean your skin before use. Use the pads on clean and
flat areas, no sweat, no oil.
2. Attach one pair or two pairs of the electrode pads to the
massage area, such as shoulder and leg.
Note: Adding a few drops of water on the pads and drying
the pads naturally will increase their longevity. Make sure
both pads on the skin and not overlapping.
3. Connect a pair of electrode pads to one lead wire by
plug them on; the other end of the wire is connected to the
left output of the device. Similarly, the other pair ofelectrode
pads is connected to the remaining wire end and the right
output of the device.
4. Turn on the device by sliding the on/ off switch on the
top of the unit.
5. Press the A button to choose Channel A. Press the M
button to try different mode and press +/- to increase or
decrease intensity. Press the B button to choose Channel B
and select your favorite mode and intensity (The modes on
Channel A can be different with that on Channel B).
Note: Remember the strength will default to the lowest
setting by each mode selection.
6. Recommended application is 10-60 minutes. Increase
10 minutes by each setting by pressing the T on the device.
The time remaining is automatically counted down until it
turns off once the time finishes.
7. Press and hold the center button for 3 seconds to lock
the screen, 3 seconds again to unlock the screen.
AFTER USE
1.
Turn off the device on by sliding the on/ off switch on the
top of the unit.