AVDT-BOB
User’s manual
v1.6
Page 5 / 25
2.3
AVDT-BOB
’s
Dante settings
The AVDT-BOB Dante settings are done via the standard Audinate Dante Controller.
Download Dante Controller on the Audinate web site at the following web address
https://www.audinate.com/products/software/dante-controller
Install Dante Controller by double clicking on the download file.
Start Dante Controller to detect your AVDT-BOB Dante devices and control
settings:
To change AVDT-BOB name, Double click on the device label
Select “
Device Config
” tab in the new windows
and modify the “
Rename Device
” field
Consult the Audinate Dante
Controller User’s manual
for any other information
Notices: Using the Dante controller, it is possible to run commands by setting specific
Dante names in an AVDT-
BOB (all command name must be filled with the maximum of ‘x’ at
end):
-
Setting
AVTxCMD-GIPxxxxxxxxxxxxxxxxxxxx
as Dante Name in an AVDT-BOB will request
to get back the IP address of the AVDT user Interface. In reply the Dante Name of the
module will be changed back to
AVTxANS-GIP-a-b-c-dxxx..xxx
where a.b.c.d is the IP
address of user interface (
AVTxANS-GIP-169-254-0-145xxxxxx
for instance)
-
Setting
AVTxCMD-FIP-192-168-0-222xxxxxx
as Dante Name for an AVDT-BOB will set its
IP address to 192.168.0.222. When done, the device returns to its previous name
-
Setting
AVTxCMD-FFSxxxxxxxxxxxxxxxxxxxx
as Dante Name for an AVDT-BOB will request
to call back parameters from factory settings and to reset the AVDT-BOB
