2 Use cross head screwdriver to remove the fixing screw on the right, and then take
out the main brush, rubber brush and brush coupler together as shown in the following
drawing.
5). Put the brush coupler and brushes back and tighten the screw.
Cleaning the Vacuum Inlet Lid
1) Switch off power. Turn the Cleaner upside
down on flat surface.
2) Take the Vacuum Inlet Lid out as per following
drawing
3) Clean the Vacuum Inlet Lid and the fan-shaped
mechanism to ensure good ventilation
4) Guide the hinge tabs on the Vacuum Inlet Lid
back into their holes carefully
- 7 -
INTELLIGENT CLEANER
OPERATING MANUAL
Brush coupler.
3 . Clean the chamber where the brush is located and the contaminants on brush and
rubber brush.
4 . Wipe out dirt on the metal shaft and bearing of the brush coupler and the brushes
(this may not be necessary to do after every cleaning) as per following drawings. If
necessary can put a little lubricant to it.
