6
CAUTION
DO NOT
discard your Original Equipment clip! Store it near the engine
start switch; it serves as a back-up to the AUTOTETHER
TM
System
switch.
On the end of the host unit cord you will find an actuator clip. Push
the actuator clip onto the kill switch. As you push the actuator clip
on, note that the plunger pin inside the end clip needs to be fully
compressed and locked. You should hear a click when it locks.
Because the clip is spring-loaded, it will take more force to position
it on the switch than your Original Equipment clip.
Press the recessed ON/OFF button on each FOB; the light on each
FOB should illuminate steady GREEN.
Press the POWER button on the Host unit – AUTOTETHER
TM
will
automatically initiate a system check, battery test and searches for
active FOBs.
o
Host POWER light flashes GREEN – HOST batteries are good
o
Host RESET light flashes AMBER - the system is searching for
active FOBs
WARNING!!
If the POWER light is AMBER, the batteries are low and should be
replaced.
If the light is RED, batteries are dangerously low and must be replaced
immediately.
It is strongly recommended that all of the batteries in the
AUTOTETHER
TM
system be replaced at the same time.
The System is ready when:
Host POWER light flashes GREEN – the HOST batteries are good
The FOB Signal lights on the HOST flash GREEN for each FOB
recognized
The light on each FOB flashes GREEN every 4 seconds
After about 2 minutes, the RESET light and the FOB Signal lights on the
HOST will go out. The Host POWER light will continue to flash every 4
seconds to indicate that the system is on and operational.
