A
U
T
O
T
E
C
H
Installation Instructions
Phone 949.240.4000 Fax 949.240.0450
32240-E Paseo Adelanto, San Juan Capistrano, CA 92675
Part Number:
10.199.023K
Description:
HD Polyurethane mount set, A4 Chassis trans/subframe
Notes:
Our A4 transmission brace bushings reduce engine ‘rock’ under acceleration,
resulting in better power transfer
Procedure:
1) Remove the transmission brace from the car.
Using a 16mm and a 13mm wrench, unbolt the 4 bolts marked A and B (below) and remove
the brace from the car.
A: 15ftlb/20Nm plus 90°; B: 30ftlb/40Nm plus 90°
www.autotech.com
1/1
2) Disassemble the brace by removing the bolt from the end.
3) Replace the rubber inserts with the new polyurethane versions. Use the diagram below as a
reference for proper location and orientation. Re-install the bolt and captive nut.
18 ftlbs / 25Nm
4) Re-install the brace on the car and tighten to specification (see step 1 for torques).
