Quick installation Guide
http://www.autostart.ca
P.9
Valet mode.
Make sure the remote car starter is able to properly enter and exit valet mode. When
setting the remote car starter into valet mode, pressing the lock button will lock the doors without
activating the starter kill. (Refer to the user guide for further information on valet mode.)
Most comebacks are the result of misunderstandings about how a product works or performs.
Take the time to properly explain all functions and features to the customers before they leave
the premises. Doing this will save time and money.
TROUBLESHOOTING
Problem:
D2D brake could not be detected.
Cause:
The unit is locked in W2W brake.
Solution:
Reset the remote starter power.
Problem:
The remote does not respond to the remote starter.
Cause:
The remote and antenna are not paired nor programmed to the module.
Solution:
Do the transmitter programming procedure.
Problem:
The remote confirmed the successful pairing but the commands are not executed by the remote
starter.
Cause:
The remote is paired successfully, but not properly programmed to the remote starter.
Solution:
Reset the module and redo the transmitter programming procedure.
Problem:
During transmitter programming, the parking lights are flashing to confirm the successful pairing but
the remote failed to play the melody.
Cause:
The remote is not properly paired to the antenna.
Solution:
Reset the module and redo the transmitter programming procedure.
Problem:
The remote starter responds to commands but the remote does not provide confirmation feedbacks.
Cause:
The transmitter was improperly programmed to the remote starter.
Solution:
Reset the remote starter and redo the transmitter programming procedure.
DIAGNOSTICS – PARKING LIGHT FLASH TABLE
Diagnostic table for start failure.
Parking lights flashes
Cause
1
(Manual transmission only)
Ready mode is not activated.
1 slow
2 quick
The system is set to valet mode.
1 slow
2 quick
2 quick
The system is in Home valet
3
(Automatic transmission only)
The parking brake is active.
Yellow loop is connected.
4
Brake wire is active.
5
(Manual transmission only)
Tach signal is not programed.
6
A tach signal is detected before Ignition.
10
Hood wire is active.
Diagnostic table for shutdown.
Parking lights flashes
Cause
1
Runtime has expired.
2
Shutdown by remote.
Ready mode is activated.
3
Failed start (VTS or tach failure, depending on selected).
4
Brake shutdown.
10
Hood shutdown.
Flash for 30 sec.
Panic mode.
Flash for 60 sec.
Alarm triggered.
Note: The installer can also use the PRG-1000 to diagnose shutdown and remote start failures.
Refer to the PRG-1000 manual guide.