background image

AS-6210

 User Guide 

P. 8

 

Passive or Active Arming 

By default, the system is configured to 

Passive Arming Mode

. In Passive Arming Mode, 

the Starter Kill and the Alarm will automatically arm 

30 seconds 

after the last door is 

closed. The system will not arm itself if a door is left open. 

Important note:

 When the system re-arms automatically or if there is an Alarm condition, you 

can disarm the system by simply pressing the 

UNLOCK

 button. 

Disarmed Notification 

(

OFF

 by default.) This feature will notify the user when the vehicle was left disarmed: after 

the Engine has been shut down and all doors have been closed, after 10 seconds the 

horn will honk once if the doors have been left unlocked. 

Shock Sense And Warn-Away Sense 

(Both enabled by default.) This system can react to a full shock by triggering the Alarm; it 

can also respond to a lighter shock (30 % of the strength of a full shock) by giving a 

warn-away

 (without triggering an Alarm condition). When the Engine is running after a 

remote start, however, 

the system will prevent any Alarm condition to be triggered 

it will still give a warning sound if 

warn-away 

is enabled. 

Siren Chirps 

(On by default.) The siren will chirp to confirm the system‘s basic operations: 

 

By default, when the doors are being 

locked

 the siren will give 

one chirp

 if none of 

the zones are active. 

 

If a 

zone is active 

as the doors are being 

locked

, the siren will give 

three chirps

 

When the doors are being 

unlocked

, the siren will give 

two chirps

 if no intrusion 

was detected. 

 

If an 

intrusion was detected

, as the doors are being 

unlocked

 the siren will give 

four chirps

The system can alternatively be set to: 

 

Warning Mode

 (no chirp during lock/unlock – unless a zone is active when locking, 

in which case there will be 3 chirp upon locking – or unless the alarm was triggered, 

in which case there will be 4 chirps when unlocking); 

 

Open Zone Notification

 (the system will warn for doors opened up to 10 seconds 

after arming). 

 

No Chirp

 (the vehicle will not chirp under any circumstance). 

Open Zone Notification: 

(Off by default.) 

This feature will warn the user when a Door is left open: upon the 

arming of the Module, a 10-sec. notification delay will take place, after which the Siren 

will chirp 3 times if an open door is detected. 

Ignition-Controlled Door Locks 

This is an added security feature. If your system was installed with the Ignition-Controlled 

Door Locks option, the doors will automatically be locked as soon as the key is turned to 

the 

IGNITION ON (RUN)

 position while the brakes are pressed. When the key us turned to the 

OFF

 position, the doors will automatically be unlocked. 

Summary of Contents for AS-6210












Reviews: