SYSTEM LED FLASH RATE
The AS-4565TW system comes with a full status LED to be mounted on your dash. The
LED displays the status of the system. When you press the UNLOCK button, the LED state
will inform you of any alarm situations while you were away from your vehicle, and will let
you know in which area the alarm was set off.
LED State
Flashes
System Status
OFF None
Disarmed/Normal
ON
Solid (No Flashes)
Disarmed/Valet Mode
Flashing Constant
Flashing
Amred
Flashing
Pause & 1 Flash
Panic Mode
Flashing
Pause & 2 Flashes
Hood
Flashing
Pause & 3 Flashes
Shock Sensor
Flashing
Pause & 4 Flashes
Door Intrusion
READY MODE
To remote start a manual transmission vehicle, the system must absolutely be placed in
Ready Mode each time the user leaves his vehicle, if he wants to be able to remote start it
later.
ACTIVATING READY MODE
1.
Make sure that all doors are closed, as well as the hood.
2.
The transmission must be in neutral.
3.
Start the vehicle with the key.
4.
Engage parking brake.
5.
Press any button on the remote until the parking lights flash 3 times. The parking
lights will stay on.
6.
Turn the key to the OFF position and take it out of the ignition (the motor should
stay running).
7.
Exit the vehicle, close all doors and press on the LOCK button to lock the doors.
The motor will shut off.
OR
Press the START button. The motor will shut off, but the doors will not be
locked.
GETTING OUT OF READY MODE
When your vehicle is placed in Ready Mode you can start the vehicle by remote as many
times as you like. However, the Ready Mode will be deactivated automatically should one
of the following situations occur:
x
A door or the hood is opened
x
The brake pedal is pressed
x
The parking brake is engaged
x
The key is turned to the ON position.
The parking lights will flash slowly 3 times to indicate that the vehicle is no longer in
Ready Mode.
You must set up the Ready Mode once again if you wish to be able to remote start.
STAYING IN READY MODE
If you wish to return to your vehicle after having set up the Ready Mode, you can have
access to your vehicle without getting out of Ready Mode. All you need to do is
remote start your vehicle, disarm the system if necessary, then open the door and enter
the vehicle. When you are ready to leave your vehicle once again, simply close the
door and turn the vehicle off by remote. The system will stay in Ready Mode.
REMOTE STARTING
Press the START button for approx. 1 second. The parking lights will come on,
informing you that the unit has received your signal. Approx. 5 seconds later, the
engine will start. The parking lights will remain on during the pre-programmed run
time.
If the vehicle doesn’t start the first time, the system will shut off, wait a few seconds,
and try to start the engine again. It will try to start the engine the amount of
programmed times (2, 3 or 4) before giving up.
DRIVING-OFF
With the vehicle running under remote control, press the UNLOCK button to
DISARM and UNLOCK the doors.
Enter the vehicle and do the following:
x
Turn the ignition key to the ON position. (
Do not turn the key to the “START”
position with the engine running. This will cause the starter motor to re-
engage.
)
x
Press the brakes to disengage the remote starter unit. You are now ready to drive
off.
PANIC MODE
In a panic situation, you can activate the Panic Mode. This will disable the Valet
Mode, shut down the engine, unlock the doors, disarm the starter kill and sound the
siren for 1 minute.
To activate Panic Mode, press and hold the LOCK button for approximately 4 seconds
until the siren goes ON and the parking lights flash.
The Panic Mode will automatically shut off after 1 minute.
NOTE:
If you want to stop the Panic Mode before the 1 minute delay, press the
UNLOCK button for approximately 4 seconds.
5
4
