4
ACTIVE ARM MODE
In Active Arming Mode, to
disarm the system, unlock the doors and deactivate the starter kill if
installed, press and hold the Unlock button
until the
siren chirps twice
in confirmation. Notice also that
the parking lights confirm the system disarming by flashing twice.
Finally, note that if an
alarm condition occurs and the siren is on, disarming the system will end the
alarm condition.
First press of Unlock will mute the siren; the second press of Unlock will disarm the system.
IDLE MODE
When programmed this option allows the user to engage the system to take over the vehicle while it is
already running. This option will keep the vehicle running for the programmed run time or until shut down
by remote control.
To activate Idle Mode you must do the following:
1. Select Mode 1, Function 2, and Option 2 for gasoline engines.
2. With vehicle running press Lock, Unlock or Start button on the transmitter until the parking lights
come on.
3. Remove the key and exit the vehicle.
4. Vehicle will stay running for the entire programmed run time.
COLD WEATHER MODE
Your Autostart can be set in Cold Weather Mode. When programmed, it will start and run your engine
every 2 hours for 4-minute intervals (gas engines) or 20-minute intervals (diesel engines), during a period
of 24 hours.
To program Cold Weather Mode, press and hold the
START
button for approx. 5 seconds until the parking
lights flash 3 times.
To exit Cold Weather Mode, do any of the following:
•
Open the hood
•
Start the vehicle by remote
•
Turn the ignition ON
•
Press and hold the
START
button for approximately 5 seconds.
NOTE
: By pressing the brake, parking lights will flash once to let you know that your are in Cold Weather
Mode. You must program Cold Weather Mode each time you want to use it
PANIC MODE
In a panic situation, you can activate the panic mode which disables the valet mode, shuts down the engine,
unlocks the doors, arms the starter kill and sounds the siren for 1 minute. You can activate the panic mode
by
pressing LOCK button for approximately 4 seconds
until the siren goes ON and the parking light
flash.
TEMPORARY CHIRP DELETE
If you want to
avoid the siren chirps
in a quiet neighborhood when arming or disarming the system,
press
TRUNK button
until you see a parking lights flash. Then
within 3 seconds, press the Lock or Unlock
button
to arm or disarm the vehicle without generating the siren chirps. Note that your installer could
program the Chirp disable feature, so that you could disable the chirps permanently.
Note that chirps will still occur when arming and a zone is unprotected or when disarming and an entry was
attempted.
REMOTE START
Whether the system is armed or not, you can start the vehicle by remote. In order to do so, you must ensure
that the hood is closed, the key is not in the ignition and that the brakes aren't pressed.
Press and hold
