P. 6
User
Guide
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by handbrake
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2.
With the engine already running, apply the
parking brake
once
and release the brake
pedal.
Make sure to release the brake pedal.
2.
With the engine already running, apply the
parking brake
twice
and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3.
Within 20 sec. of engaging the parking
brake, press and hold
LOCK
,
UNLOCK
or
START/STOP
on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
a.
LOCK
to lock the doors and shut down the engine;
b.
UNLOCK
to unlock the doors and shut down the engine;
c.
START/STOP
to shut down the engine without affecting the doors.
Note:
The vehicle will also enter Ready Mode once the engine run time expires.
Remote-starting
Press the
START/STOP
button for approximately 1 second. The parking lights will come
ON
to inform
you that the remote car starter has received your signal. Approximately 5 seconds later, the engine
will start. The parking lights will remain
ON
during the pre-programmed run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down; wait a few seconds and
try to start the engine again. If your vehicle is equipped with an automatic transmission, there will
be 3 start attempts before the system gives up.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm the Starter Kill
and/or the OEM-style alarm (if installed) and unlock the doors. Enter the vehicle and do the
following:
Turn the ignition key to the
IGNITION ON (RUN)
position. (
Do not turn the key
to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Remote Starter Features
Idle Mode
Convenience feature:
Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.