AS-1725 SH
Installation Guide
P. 15
a. To increase the Horn pulse by 3 ms, press the
LOCK
button.
b. To decrease the pulse by 3 ms, press the
UNLOCK
button.
c.
To increase the pulse by 10 ms, press the
START
or
STOP
button.
d. To decrease the pulse by 10 ms, press the
TRUNK
button.
5.
To save the new settings: press
LOCK
and
UNLOCK
. If 3 chirps are returned the new
settings have been saved.
Table 7: Adjusting Chirp Duration
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will chirp with the new settings, except in the
following cases:
x
When the lower limit of 5 ms is reached, there will be a 1/4-sec. chirp.
x
When the upper limit of 200 ms is reached, there will be a 3/4-sec. chirp.
A system reset will set the Remote Car Starter back to the default values: 30 ms.
Testing
Before putting back the vehicle together, it is recommended to check that the system
operates properly. The following testing procedures should be used to verify proper
installation and operation of the system. Before testing, make sure that all connections are
soldered and that the unit is plugged in.
Remote-start the Engine and listen for Starter drag.
If the Starter cranks for too long,
carry out another Tach Programming procedure.
Hood Switch shutdown.
with the vehicle running under the Remote Car Starter, open
the Hood; the vehicle should shut down. If it does not shut down, check the Hood Pin-
switch and its connector.
Brake shutdown circuit.
With the vehicle running under the Remote Car Starter, press
and release the Brake Pedal. The Engine should shut down immediately. If the Engine
continues to run, check the Brake Switch connection.
OEM Alarm Control.
Make sure the Module is able to arm and disarm the OEM Alarm
(if applicable).
Door Locks and Trunk Testing.
Make sure each of these options respond to the
Transmitter (if installed).
Starter Kill option.
Sit inside the vehicle with all Doors closed. Arm the vehicle, then try
to start the Engine with the Key. They Engine should not start. If the Engine starts,
rewire the Starter Kill to reach proper operation.
Valet Mode.
Make sure the Remote Car Starter is able to properly enter and exit Valet
Mode. When setting the Remote Car Starter into Valet Mode, pressing the Lock button
will lock the Doors without activating the Starter Kill. (Refer to the User Guide for further
information on Valet Mode.)
Idle Mode.
Make sure the Vehicle properly enters and exits Idle Mode.
Most comebacks are the result of misunderstandings about how a product works or
performs. Take the time to properly explain all functions and features to the customers
before they leave the premises. Doing this will save time and money.
