Note:
Pressing the
LOCK
and
UNLOCK
buttons at the same time will activate the
AUX2
output.
Remote-starting Your Vehicle
Press the
START
button for approx. 1 second. The parking lights will come
ON
, informing you that
the unit has received your signal. The engine will start approximately 5 seconds later. The
parking lights will remain on during the entire pre-programmed engine run time.
If the vehicle doesn’t start the first time, the system will shut off, wait a few seconds and try to
start the engine again. It will make three start attempts before giving up.
Vehicle Presets
Heater and Heated Seat:
When leaving the vehicle it is recommended to preset the accessory
controls in preparation for the next remote start. Settings for the blower motor (fan), front and
rear, as well as heated seats (if equipped) should not be left on
HIGH
. It is recommended to
leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers, Radio and Headlights:
Certain vehicles require the radio and / or
windshield wiper and / or headlight circuits to become energized while running under remote
start. When leaving the vehicle you must ensure that the windshield wiper and headlight
switches are
OFF
. Leaving the headlight switch
ON
on certain types of vehicles could cause them
to remain
ON
even after remote starter shut down, resulting in a dead battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm the system
(and unlock the doors if keyless entry is installed). Enter the vehicle and do the following:
1. Turn the ignition key to the
IGNITION ON
(
RUN
) position.
2. Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Caution!
Upon entering your vehicle after it has been remote-started,
do not turn
the key
to the
CRANK
position while the engine is running. This would cause the starter motor to re-
engage, unless the anti-grind feature is installed.
Advanced Features
Idle Mode
This feature allows you to remove the ignition key from the ignition switch and leave the vehicle
running without the key while you are away from your vehicle, until the pre-programmed engine
run time expires or until it the vehicle is shut down with the remote control. This feature may be
handy if you need to make a short stop (for a delivery, to a convenience store, etc.). To learn
more about the run time, see Engine Run Time on page 8.
AS-1535 SH
User Guide
P.3
