P. 4
User Guide
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
OFF
.
Valet Mode Using the Valet Button
(Available only of the plug-in Valet switch is installed)
To put the system
into
Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Press (for at least 1 second) and release the Valet Button. The parking lights will
flash 3 times and then turn the key to
IGNITION OFF
position. The L.E.D. will come on.
To take the system
out of
Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Press (for at least 1 second) and release the Valet Button. The parking lights will
flash twice and the L.E.D. will go
OUT
.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN)
position.
Panic Mode
Note:
Panic mode can only be activated if the horn has been adequately configured
by your installer and if button
Ι
is programmed as
LOCK
or
UNLOCK
button.
In an emergency situation, you can activate panic mode using the
Ι
button. This will:
•
shut down the engine,
•
unlock the doors (with the
Ι
button)
•
or lock the doors (with the
Ι
button),
•
disarm the Starter Kill and
•
activate the horn for 25 sec.
Note:
See the description of the starter kill option later in this Guide.
To activate panic mode:
•
Press and hold the
Ι
,
button for approximately 3 sec. until the sound signal starts and
the parking lights flash: this will unlock the doors before the sound signal starts.
•
Or
press and hold the
Ι
,
button for approximately 3 seconds until the sound signal
starts and the parking lights flash: this will lock the doors before the sound signal
starts.
Panic Mode will automatically shut down after 25 sec.
Note:
To stop panic mode before the end of its delay, press the
Ι
button until the sound
signal stops.
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes
(or for 20 minutes with Diesel engines); the routine goes on for a period of 24 hours.
To
enter
Cold Weather Mode:
•
Press and hold button
ΙΙ
until the parking lights flash 3 times.
To
exit
Cold Weather Mode, do any one of the following:
•
Open the hood.
•
Start the engine using the remote control.
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
•
Press and hold button
ΙΙ
for 3 seconds
(until the parking Lights flash once)
•
Set the vehicle to Valet Mode.
