6/18/2007
RS-602 REV A.
11
PROGRAMMING
A. PROGRAMMING TRANSMITTER:
Note:
This remote start system will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
PROGRAMMING THE REMOTE TRANSMITTER
1. Turn the Ignition 'switch ‘OFF/ON’ 3 TIMES and stay in the
‘ON’ position.
Within 15 seconds.
2. Push the Programming switch
2 times
holding in on the 2
nd
push, until a long chirp from the horn (optional) and the LED
starts to flash then release the valet switch. You are now in the Transmitter programming mode.
3. Press the ‘Lock’ button on the transmitter until a chirp from the horn / a flash from the parking light / the LED turns on
for 2 seconds to confirming the first transmitter is now programmed.
4. Apply the same procedure (step 3) to program 2
nd
, 3rd and 4th
.
Exit:
Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
B. FEATURES PROGRAMMING:
FEATURE “
I
” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in the ‘OFF’ position.
2. Push the Programming switch
1 time
and hold it until the LED turns on
and
(*)
one chirp with a long chirp is heard
then release the Programming switch. You are now in the feature
‘I’
programming mode.
3. Press and release the transmitter button with the Icon corresponding to the feature with the icon you want to program.
a.
The (optional) horn chirps and the LED will flash then pause indicating a previous setting.
b.
The factory default settings are always [1] LED flash, [1] horn chirp.
4 Depress the transmitter button icon again to change the feature. Simply keep re-depressing the transmitter button icon
again until the module advances to your desired setting.
5. Depress the next desired transmitter icon button corresponding to the feature you want to program.
(*) The Horn must be connected to hear the programming chirps.
Exit
:
Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default Setting
Two Chirps /
LED two pulse
Three Chirps/
LED three pulse
1.
H3/2 White/Blue = 1 Pulse
Remote Start
H3/2 White/Blue = 3 Pulse
Remote Start
2.
H3/8 Pink Wire = Factory
Security Disarm Signal Output
H3/8 Pink Wire = Start Status
(Shock Sensor Bypass Control)
Output
H3/8 Pink Wire = 20 Second
Ground out Key Sensor By-pass
3.
+
H2/4 Brown Wire = Horn Output
H2/4 Brown Wire =
Rearm Signal
Output
4.
+
Button
Two
Push Remote
Button
One
push Remote
Start
5.
Without ignition controlled door
locks & unlocks
Ignition controlled door locks &
unlocks
