C3 RS1100REV. A
8
been designed for use with all C I 3 compatible components. C I 3 Telematics
system is available at any authorized Autopage dealer.
This port will only operate correctly with Autopage C3 I-Datalink Modules
.
H3. 2 PIN WHITE CONNECTOR (THE LED STATUS INDICATOR):
The led indicator status should be mounted in a highly visible area such as top of the
dashboard, on top of the shifter console or on the dashboard face. Leave at least
6mm space behind the mounting location for LED housing. Once a suitable location
is chosen, drill a 6mm hole. Run the LED wires through the hole then press the 2 pin
LED housing into place. Route the LED wires to the control module.
H5: 5 PIN WIRE HARNESS:
RED / WHITE WIRE –PARKING LIGHT RELAY INPUT
—
The RED/WHITE wire is the input to the flashing parking light relay. The connection
of the RED/WHITE wire will determine the output polarity of the flashing parking
light relay.
If the vehicle you are working on has +12volt switched parking lights, you don’t need
connect this wire. This wire is already connected to +12volt.
If the vehicle’s parking lights are ground switched, cut the RED/WHITE wire,
connect the RED/WHITE wire to chassis ground.
WHITE WIRE — PARKING LIGHT RELAY OUTPUT
(+12 V 10A OUTPUT) —
Connect the WHITE wire to the parking light wire coming from the headlight switch.
Do not connect the WHITE wire to the dashboard lighting dimmer switch. (Damage
to the dimmer will result). The limitation of the WHITE wire is 10 AMP max. Do not
exceed this limit or damage to the alarm and parking relay will result.
BLACK WIRE — SYSTEM GROUND –
This is the main ground connection of the alarm module. Make this connection to a
solid section of the vehicle frame. Do not connect this wire to any existing ground
wires supplied by the factory wire loom, make the connection to the vehicle’s frame
directly.
BROWN WIRE – (+) SIREN OUTPUT –
This wire is provides power to the supplied siren. Connect the Brown wire to the
Red wire of the siren. Connect the Black wire of the siren to a stable chassis
ground.
RED WIRE — SYSTEM POWER (+12V CONSTANT) —
The RED wire supplies power to the system. Connect this wire to a stable
co12 volt source.
