Autopage C3-RS-1000 OLED Operation Manual Download Page 16

Page: 16 / 22

C3RS1000 OP 3/08

(When you are finished with the above procedures, the system's siren stops alarming and the parking
lights stop flashing, but the vehicle cannot be started and driven away.)

3. If you use one digit to be a password pin code, skip to Step 6. If you use two digits to be a password pin code,

advance to Step 4.

4. Within 15 seconds of the last digit code enter (the 1st code), turn the Ignition Switch “Off” and then “On”.
5. Within 15 seconds, enter your chosen of the second digit code by press and release the Valet Switch.
6. Turn the ignition switch to the “OFF” position. [4] Chirps form siren/horn, [3] flash from parking light to

indicate the system was disarmed.

Note:

If someone keys-in the wrong password pin code, the system allows him to make 2 mistakes. If the

            third code is still wrong, it will automatically shut down for 5 minutes. During this period the system
            will not accept any code and the LED will “pause on” (the LED will turn on 1 second
            and turn off 0.1 second).

EXAMPLE: To Override The System With The Password Code 83, you would;

1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 5 seconds, Press and Release the Valet Switch 8 times

(When finish the above procedure, the system's siren will stop alarming and the parking lights will stop
flashing, but the vehicle cannot be started and driven away.)

3. Within 15 seconds of the last digit code enter (the 1

code), turn the Ignition Switch “Off” and then “ON”.

4. Within 15 seconds, Press and Release the Valet Switch 3 times
5. Turn the Ignition Switch to “Off” position. [4] Chirps form siren/horn and [3] flashes from the parking light

will indicate the system has been disarmed.

I. VALET MODE:

(System in Disarm or Valet mode)

The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your

transmitter to a parking attendants or a garage mechanic.
When  the  system  is  in  valet  mode,  all  alarm  function  and  remote
start  functions  are  bypassed,  however  the  remote  panic  feature
and  remote  door  locks  will  remain  operational.  To  use  the  valet
mode, the system must first be disarmed.

Enter Valet Mode:

1. From the disarmed condition, turn the ignition to the “ON”
position.
2. Push and hold valet switch for 2 seconds until the LED turns on
solid. The LED will remain on as long as the system is in 'valet
mode'.

Exit Valet Mode:

1. To return to normal operation, turn the ignition 'ON'.

2. Push and hold valet switch for 2 seconds. The LED will turn off to

indicate the system has exiting the valet mode.

J. CAR LOCATOR

While the system is armed, press the

button to activate car locator function. The

siren will chirp 6 times. The parking lights will flash 12 times, for you to easily locate
your vehicle.

K. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case of an emergency.

1. Press and hold the

button for 3 second. The alarm will immediately sound and the