410: R-2:07/19
Effective Date: July 15, 2019
4.
Press and hold right programming button (4) to go down until you reach the bottom limit, then press and hold
‘Save’ button (5) until right LED (2) comes ON. Regular top and bottom shade limits are now set.
5.
Next, program the intermediate safety stop (Ignition Line) by pushing and holding the left programming button
(3) again to move the shade to your desired intermediate safety stop that allows you to still safely see the road
when driving while using the shade as a sun visor.
6.
When done, press and hold ‘Save’ button (5) until right LED (2) comes ON.
7.
Disconnect the programmer by holding the connectors and not the wires (see Illustration above point A).
8.
Release the dash switch you kept holding all along (see point 1).
9.
Now test the end limits by operating the shade as follows:
-
Ignition key is OFF: by pressing dash switch Up/Down, your shade should travel all the way from top
to bottom limit.
-
Ignition key is ON: by pressing dash switch Up/Down, your shade should only travel to Ignition Limit
(see point 4 above) and should NOT travel beyond this point to prevent obstruction of your view
while driving.
Important Note:
The programmer needs to be disconnected after the programming process is done. Never leave the programmer
connected to the motor thereafter
