407: R-1: 02/20
Effective Date: Feb 2020
All above transmitters will work with Motor 4240N in conjunction with Module 216P.
Please note that 1
st
and 2
nd
generation RF Transmitters are not interchangeable; the external Module 216P only
works with 2
nd
generation RF Transmitters.
Special Feature: Module 216P gives you the option to control a motor both remotely with an RF transmitter and
by means of a wall switch.
1.
Connect the Module output wire (A) to the short Shade power wire (B); if wired switch control is desired,
connect the wire coming from the wall switch that controls the shade to Module wire (C). This wire can be
left unused if no hardwired wall switch control is needed.
2.
Ensure the Module is connected to a 12V DC power supply (white wire to ground, black wire to 12V power).
A green light on the Module must be lit. If you do not see a solid green light, the Module is either not
properly powered or the Module may be faulty.
3.
On the RF Transmitter, select the channel you want to program by pressing the button of that channel.
4.
On the Receiver Module, press the small micro push button (D) with a ball pen point and hold until the color
of the light changes from green to red; now release it and immediately without delay press and hold the
micro push button inside the small hole on the back of the transmitter (using e.g. a paper clip) for few
seconds (on transmitter EL-213P “SET” appears on the display), then release it and immediately press the
stop button on the front of the transmitter.
For internal wiring and limit adjustments of Cellular Shade refer to QRG #21;
to 12VDC Power
(C)
- to wired switch (optional)
External RF Receiver Module EL-216P
(As an option, Module 216P can also be
fitted inside the headrail)
(D)
Micro Push Button
(A)
(B)
