Automationdirect.com Stellar SR44, User Manual

Page: 68 / 238

4–2
1st Ed, Rev B 07/31/2019
SR44 Series Soft Starter User Manual
4.0 – Electromagnetic Compatibility (EMC)
As supplied, all SR44 Soft Starters meet the standards of emission and immunity levels defined in
the IEC 60947-4-2 and EN 60947-4-2 product standards for AC Semiconductor Motor Controllers
and Starters. However, the EMC performance of the controller can be significantly affected by the
manner in which it is incorporated into the system in which it is intended to operate. To prevent
inadvertent degradation of EMC performance, attention must be given to motor cable lengths,
wiring configurations, the nature of the power supply, etc., at the design, construction and
implementation stages of a project.
4.1 – Introduction
It is widely accepted that electromagnetic compatibility between electronic and electrical products
is a desirable objective. Technical standards are increasingly stipulating levels of EMC
performance which compliant products are required to meet. The decision by the European Union
(EU) to implement a community-wide directive covering EMC caused considerable activity among
electrical and electronic equipment manufacturers and suppliers to identify, understand, and
mitigate the sources of electromagnetic interference within their products and systems.
4.2 – Applicable Standard Within the EU
The product standard which defines EMC performance for soft starters is IEC 60947-4-2 'AC
Semiconductor Motor Controllers and Starters'. (The Official Journal of the EC will list this
standard as EN 60947-4-2.) The SR44 has been type tested in accordance with the test procedures
and levels laid down in the product standard.
4.3 – Mandatory Requirements Within the EU
(Applicable to any person involved in the installation and operation of the equipment.)
The EU Directive 89/336/EEC, describes the required EMC performance of all electrical equipment
which is to be connected to a low voltage supply network. It imposes an obligation on the
manufacturer of the soft starter to provide sufficient information for installers, system integrators,
users, and anyone else connected with the installation and operation of the equipment. This
section provides the technical information to support the obligation of the manufacturer.
The provision and maintenance of compatibility extends from the manufacturer to the panel
builder, assembler, systems integrator, and ultimately to the installer and user. Anyone involved in
the installation and operation of the equipment, through a lack of knowledge, misdirection, or for
other reasons, can completely negate the initial EMC performance of the equipment.
4.4 – Guidance for Installation Personnel and System
Designers
For safety reasons, all SR44 products are intended to be installed and set to work by skilled
personnel who are capable of interpreting and following EMC guidelines correctly. Any person not
fully trained in the appropriate technology should not attempt the installation.
If you do not understand, or if you are unclear about any part of these guidelines, then please
consult your supplier. Often, consultation with the supplier can avoid unnecessary problems in
specifying and installing the correct combination of equipment.
Chapter 4: Electromagnetic Compatibility