Automationdirect.com Stellar SR44, User Manual

Page: 207 / 238

A–13
A.1.11 – Using the Pre-programmed Relay Options
This example shows the user how to program any relay on the unit via the pre-programmed
options. The option shown in the example below is the ‘Alarm’, but the instructions apply to all of
the pre-programmed relay options (see section 5.4.10), and for all of the relays since they are all
programmable.
1. With ‘Stopped and ready’ shown on the display, press the ENTER button.
2. With ‘Applications’ shown on the top line of the display, press the
쑼
button until ‘Outputs’ is
shown at the top of the display.
3. Press ENTER to select the ‘Outputs’ menu.
4. With ‘K1’ on the top line of the display, press the
쑼
button until ‘K2’ is shown at the top of the
display.
5. Press ENTER to select ‘K2’.
6. With ‘Map From’ on the top line of the display, press the
쑼
button until ‘K=Alarm’ is shown on
the top line of the display.
7. Press ENTER to select ‘K=Alarm’. The display will flash twice to confirm the user’s selection.
8. Press the # button three (3) times to return to ‘Stopped and ready’.
To keep the above settings, they must be permanently saved. See section A.1.5
Enter
#
Enter
#
1
2
3
4
5
6
#
8
8
8
7
(press button multiple times, or hold to scroll)
(press button multiple times, or scroll)
K1
K2
K2
Appendix A: Setup Examples
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019