WARRANTY
Subject to all of the matter set out below, Automatic Technology Australia Pty Ltd (“ATA”) WARRANTS for twelve (12) months from
the date of purchase (specified in the tax invoice receipt) that the CRX Series Receiver (the “Product”) is free of any defects in
material and workmanship rendering it unmerchantable.
This warranty referred to above applies only where:
a) the consumer seeking to rely on the said warranty;
1) returns the Product which it claims to be defective; and
2) presents the relevant sales docket and this warranty document, to the retailer from whom the Product was purchased to
confirm that date of purchase; and
b) the purchaser notified ATA or the retailer from whom the Product was purchased of the alleged defect in the Product
immediately upon experience or learning of the alleged defect.
Except for the warranty against defects in material and workmanship set out above, ATA gives no warranties of any kind whatsoever,
whether express or implied or whether statutory or at common law, in relation to the Product, and all warranties of fitness for
particular purpose and other warranties of whatsoever kind relating to the Product are hereby declaimed. Without limiting the
generality of the foregoing, ATA disclaims any liability of whatsoever nature in respect of any claim or demand loss or damage which
arise out of;
a) accidental damage to or normal wear and tear to the Product or to the Product’s components;
b) flood, rain, water, fire or lightning;
c) incorrect, improper or unreasonable maintenance and/or use;
d) installation, adjustment or use other than ATA which is not in accordance with the instructions set out in installation instructions
incorporated in the document;
e) attempted or complete modification or repairs to the Product carried out by a person who is not authorised by ATA to carry out such
modification or repairs;
f) radio (including citizen band transmission) or any electronic interference,
g) damage caused by electrical surges,
h) damage caused by insects.
ATA’s liability under the warranty set out above is limited, at ATA’s absolute option, to replacing or repairing the Product which ATA,
in its unfettered opinion, considers to the defective either in material and/or workmanship or to credit the consumer with the price at
which the Product was purchased by the consumer. Where the Product is retailed by any person other than ATA, except for the
warranty set out above, such person has no authority from ATA to give any warranty or guarantee on ATA’s behalf in addition to the
warranty set out above.
Automatic Technology Australia Pty Ltd
17-19 Advantage Rd Highett Vic 3190 Australia
T: +61 3 9532 2788 F: +61 3 9532 2799
E: [email protected] W: www.ata-aust.com.au
© July 2004. All rights reserved. SecuraCode
®
is a registered trademark of Automatic Technology Australia P/L.
In an ongoing commitment to product quality ATA reserve the right to change specifications without notice.
Printed for Export.
SPECIFICATIONS
Power Supply:
12V-24V AC or DC
Frequency:
433.92MHz
Memory Capacity:
111 Transmitters
Programmable Modes:
Pulse, Hold. Timer*
Controlling Outputs (CRX-1):
1 x Common
1 x Normally Open
1 x Normally Closed
N.B. CRX-2 has two relays and two of each controlling output
Relay Contact Rating:
1 amp @ 24 volts DC
Antenna Wire Length**:
170mm
*Timer mode available with ATA's Universal Programmer.
** An optional co-axial antenna is available for use with the
receiver in difficult reception areas. The antenna has to be
mounted as high as possible so that it is not obstructed, e.g. on
top of a fence, or on a wall at the front of a garage, etc. Connect
the core of co-axial lead to replace the existing antenna wire
(inner screw socket). Connect shield to the spare (outer) screw
socket.
ANTENNA
AC SKT
CONNECT CO-AX
SHIELD
CONNECT CO-AX
CORE
PWR SKT
