GDO-12 HIRO Installation Manual
10
WARNING! The opener must not
be used with a door incorporating a
wicket door.
WARNING! The doors axle must be
securely clamped otherwise the door
can loose spring tension.
WARNING! The door and its springs
are under significant tension.
Adjustments should only be carried
out by experienced persons, as
this function can be dangerous if
not performed under strict safety
procedures.
Fig 6.3
6.3.1 Mounting The Opener
a. Check the drive gear rotates freely, by pulling the string handle
down (there will be a click) to disengage opener. Then move the
forks from side to side by hand
b. Slide the opener over the door axle and into the drum of the door
(Fig. 6.3)
.
c. Ensure the internal gear is pushed in as far as possible (without
interfering with the door curtain) and that the door drum’s wheel
spokes are completely between the opener’s drive forks.
d. Evenly tighten the supplied nuts on the clamp assembly of the
opener to a torque setting of 40Nm.
e. Remove the safety rope and door stand or prop.
f. Connect the power cort to a suitable powerpoint, but
DO NOT
switch on.
g. Secure the power cord away from any moving object (e.g the door)
with the cable clip supplied.
h. With the opener still disengaged, pull the door up and down to
make sure it runs freely.
NOTE
- If the manual release handle is more than 1.8 metres from floor
level when the opener is installed, extend the handle to a height less
than 1.8 metres.
6.3.2 Optional Safety Beams
The Safety Beam Kit provides additional safety by preventing the door
closing when the beam is blocked by a car, child etc. When the Safety
Beam Kit is installed the Auto-close feature can be enabled if required.
To install the Safety Beam Kit, refer to the Safety Beam instruction
supplied with the kit.
6.3 Fitting the Opener
6.4 Auto-Close
WARNING! It is compulsory to have
Safety Beams installed when using
Auto-Close mode.
Auto-Close mode is a function that automatically closes the door after
a pre-set time. Safety beams must be installed in order to run the Auto-
Close function. There are two types of Auto-Close available:
(i) Standard auto-close - the door will Auto-Close after a programmed
time. In this mode the timer starts to countdown as soon as the door is
fully open. This function is useful in case the safety beam does not get
triggered.
(ii) Safety Beam triggered auto-close - the door will auto-close after a
programmed time. In this mode the timer starts counting down only
when the safety beam is triggered. ie car leaving the garage.
To enable the Auto-Close function:
a. Press and release the MODE button until the Spanner LED is
highlighted.
b. One of the word LEDs (LAMP etc) will highlight. Press the BLUE
CLOSE button to move to the particular parameter:
(i) two (2) times to get to PE A/C or
(ii) three (3) times to get to standard A/C.
c. Press RED STOP / SET button to enter A/C parameter.
d. The OPEN, STOP and CLOSE LEDS will now flash.
The default setting for Auto-Close is OFF.
e. Press the OPEN button to move through options.
f. Press the RED STOP / SET button to save the
parameter’s new value or press MODE to leave the
value unchanged - flashing will stop.
LED Indicators
Parameter
OPEN
OPEN &
STOP
STOP
CLOSE &
STOP
CLOSE
A/C LED
A/C Function
90s
60s
30s
15s
OFF
A/C & BEAM LED’S
P.E A/C Function
60s
30s
15s
5s
OFF
Fig 6.4
