TRIOCODE
TM
128 TECHNOLOGY
Only transmitters with the TrioCode
TM
128 Technology can operate with
the latest Receivers, reducing the chance of interference from other radio
frequency sources. TrioCode
TM
128 transmitters have the ability to code
into earlier model receivers.
Every time a transmitter is used a new security code is generated from over
100 billion possible code combinations. This greatly enhances the security
of the system and makes “code grabbing” a thing of the past!
UNIVERSAL PROGRAMMER
An ATA Universal Programmer can be used to set timer (adjustable from
0.00 to 655.34 seconds), Edit, back up /restore transmitters.
T
rioCode™128
IMPORTANT NOTE:
Only TrioCode
TM
128 Technology
Transmitters are compatible with these products.
STORING TRANSMITTER CODE
a. Press and hold;
i. FHCRX-1 and FHCRX-2: SW1 (for Relay 1) or SW2 (for Relay 2) on the
receiver board
ii. FHRX-2: SW1 (for Channel 1) or SW2 (for Channel 2) on the receiver
board.
The led will start to flash
b. Press the transmitter button you would like to use to control the device
for two (2) seconds. The led will start to flash faster.
c. Release the transmitter button and pause for two (2) seconds. Press the
same button again for two (2) seconds. The led stays on for a second and
turns off.
d. Release SW button.
e. Press the transmitter button to test operation.
DELETING A SINGLE TRANSMITTER’S CODE
a. Press and hold;
i. FHCRX-1 and FHCRX-2: SW1 (for Relay 1) or SW2 (for Relay 2) on the
receiver board
ii. FHRX-2: SW1 (for Channel 1) or SW2 (for Channel 2) on the receiver
board.
The led will start to flash
b. Press the transmitter button you would like to remove from receivers
memory for two seconds. The led will start to flash faster.
c. Release the transmitter button and pause for two seconds. Press the
same button again for two seconds. The led will slowly flash two times
d. Release SW button.
e. Press the transmitter button to confirm that it has been removed.
DELETING ALL STORED TRANSMITTER CODES
a. Turn the power off to the receiver.
b. Press and hold SW1 button.
c. While holding SW1 turn power on again. After 15 seconds the Coding
LED will illuminate to indicate that the receivers memory has been cleared.
d. Release SW1. All the stored codes should now be deleted. Confirm this
by pressing the transmitters previously used to operate the device. There
should be no response.
