SL 90X-91X
Technical Manual
NAM-SL 90X-91X-TM-04-EN-E
With a constant view to adopting the latest technological developments, Automatic Systems reserves the right to amend the above information at any time
.
p. 40/66
10.
Instructions: Mechanical Adjustements and Operations
This section details steps required to adjust, remove or replace parts that could require maintenance.
Part replacement frequency depends on the service interval, which is based on time elapsed or number
of cycles. Please follow the maintenance schedule for optimal SmartLane performance (see
Section 8.3.
10.1.
INSTRUCTIONS: REMOVING A PANEL
1.
Unlock the panel [1] using key No. 004 (see
2.
Pull the upper end of the panel towards yourself.
3.
Unscrew the thumbscrew holding the ground cable [3] and the security cable.
4.
Pull the panel up until the prongs [2] are removed from their notches.
5.
Make sure to properly reinstall the ground and security cables [3] before reinstalling the panel.
6.
Always confirm panel position and clearance with moving obstacle before operating the unit (see
Section 9.19.
, point
2).
You may need to remove more than one panel to detach the one you wish to remove
as the panels are latched into one another.
To avoid modifying the alignment of the DIRAS, do not tighten the thumbscrews too
much when putting the cover plate back on.