WIRING DIAGRAMS
FUSE 2A
JUMPER 6
RED (+12V)
ORANGE/BLUE (LOCK NC)
BLUE/WHITE (CH1 LOCK)
BROWN/BLUE (SEE PAGE 3)
ORANGE/GREEN (UNLOCK NC)
GREEN/WHITE (CH2 UNLOCK)
BLACK (GROUND)
YELLOW/BLACK (IGNITION INPUT)
ORANGE/WHITE (CH3)
BLUE/WHITE (CH4)
RED/WHITE (CH5)
GREEN/WHITE (CH6)
BROWN/WHITE (CH7)
PINK/WHITE (CH8)
BLUE/BLACK (CH9)
YELLOW/BLACK (CH10)
GREEN (CH11)
BLUE (CH12)
VIOLET (CH13)
GRAY (CH14)
BROWN (CH15)
ORANGE (CH16)
PINK (CH17)
YELLOW (CH18)
FUSE 15A
KL700
KL1000
KL1600
KL1800
WINDOW DOWN
NEGATIVE OUTPUT WIRE
DO NOT USE CHANNEL 9 OR 10
NEGATIVE OUTPUT WIRE
DO NOT USE CHANNEL 9 OR 10
WINDOW UP
12V
GROUND
WINDOW
MOTOR
UP RELAY
DOWN RELAY
CUT
CUT
ALARM REMOTES, GARAGE DOOR OPENERS, ETC.
RELAY
+
–
87
87a
30
86
85
87
87a
30
86
85
87
87a
30
86
85
POWER WINDOWS & MOTORS
+
–
12 VOLTS WHEN
SWITCH IS PUSHED
1.
Disassemble the remote to gain access to the circuit board.
2.
Locate the button to be triggered by the keyless entry system. The
button will have an input, and an output. To test, use a wire to jump
the connections of the button.
3.
Connect the INPUT wire to terminal 30 of the relay.
4.
Connect the OUTPUT wire to terminal 87 of the relay.
5.
Connect terminal 86 to constant 12 Volts.
6.
Connect terminal 85 to the keyless entry unit's channel wire.
7.
Reassemble the remote and place it under the dash.
IMPORTANT NOTICE: Upon completion of
installation, you may have extra unused wires
on the wiring harness. Do not be concerned.
These wires are used for features available on
other models.
BATTERY
