Autodesk HP xw9400, Hardware Setup Manual

Page: 14 / 54

12 Press any key.
A message stating that the system ROM flash was successful appears.
13 Verify system BIOS settings. See Checking Your System BIOS Settings on page 8.
14 Select File | Save Changes and Exit.
Checking Your System BIOS Settings
You do not normally need to adjust these settings. BIOS settings for the workstation are provided here for
informational purposes only.
To enter the system BIOS, you must press F10 while booting the workstation.
The following table lists the proper Autodesk certified BIOS settings. Items not listed are set to their default
factory settings.
Value Item BIOS Menu
Optical Drive Boot Order Storage
USB Device
Integrated SATA Boot Order, Hard Drive
Integrated IDE
Disabled OS Power Management, ACPI S3 Support Advanced
Enabled Chipset / Memory, ECC Support
Enable Chipset / Memory, Memory Scrubbing
Enable Chipset / Memory, Memory Node Interleave
Enable Chipset / Memory, PCI Serr# Generation
Enable Chipset / Memory, Net Watchdog Timer
Disabled Chipset / Memory, ACPI Bus Segmentation
Enabled Chipset / Memory, HPET
Disabled Device Options, S5 Wake on LAN I/O
WARNING Before installing Red Hat
®
Linux
®
, validate the BIOS Settings.
Restoring BIOS to Default Factory Settings
If there is any doubt about whether items contain factory default values, the following procedure restores
default factory settings.
To restore default factory BIOS settings:
1 Press F10 while booting the workstation to enter the system BIOS.
2 Select File | Default setup | Restore Factory Settings as Default.
3 Press F10 to accept the changes.
4 Select Apply Defaults and Exit, then press F10 to confirm.
8 | Chapter 2 Getting Started