STEP 1
Determine Installation Type and Options
Depending upon the requirements, the AC100GPS3G module can be installed
in two ways.
Type1
–
AC100GPS3G
GPS Tracking ONLY!
Type2
–
AC100GPS3G
GPS Tracking with starter kill and/or input
STEP 2
Complete the wire connections according to the selected installation type
Red
: 12 Volts (+) Constant
White
: Ignition (+) (MUST be a true ignition source)
Black: Ground
Green
: Starter Disable Output (-)
Yellow
: Input 1(-) Optional
GROUND MUST BE CONNECTED DIRECTLY TO CHASSIS WITH PAINT REMOVED
STEP 3
Position the AC100GPS3G Module in an Optimal Location
Failure to adhere to these suggestions will result in a weak cellular and/or GPS signal and will
affect the performance of the device.
• Secure in upper portion of dash in a hidden location with correct side pointing
skyward (label will indicate proper orientation). Example: Above instrument cluster.
• Do not cover with metal or position near any source of interference (Vehicle Radio, BCM).
Keep a safe distance of at least 24”.
STEP 4
Confirm LED Status
e
n
il
n
O
/
d
e
t
c
e
n
n
o
C
g
n
i
h
s
a
l
F
:
e
u
l
B
Green: 1 Flash / Second Valid GPS
Please see the install diagrams for detailed instructions and wiring.
CALL
NOW
CERTIFIED
TRACKING
SOLUTIONS
1
Type 2
AC100GPS3G with Starter Kill and/or input (optional)
Green - Starter Disable Out (-)
Yellow: Input 1 (-) OPTIONAL
RELAY
Vehicle Start
Interupt Wire*
CUT
Red
White
87A
30
85
86
White - Key Ignition Source (+)
Red (12V+) - Constant
Fuse
Black - GND
Black
Blue
Type 1
AC100GPS3G only
1. Connect Red wire to Co12V and fuse.
2. Connect Black wire to Ground.
3. Connect White wire to True Ignition (+).
ATTENTION:
Connecting the device to
24V
or
12V to the
Brown
or
Blue
wire
WILL VOID THE WARRANTY!
Green - Starter Disable Out (-)
Yellow: Input 1 (-) OPTIONAL
White - Key Ignition Source (+)
Brown/Blue - DATA ONLY
Red (12V+) - Constant
Fuse
Black - GND
1-2-3!
Numerous installation options exist to interrupt a vehicle’s start sequence.
Please see one possible option below.
Vehicle Start Interrupt Wire
This is a wire that when cut the vehicle is not able to be started by a key.
Due to data bus systems on newer vehicles this wire may not be at the
ignition switch. When cutting a wire be sure to test that the vehicle cannot be
started by key and when reconnected the vehicle starts without fault codes
being displayed by the vehicle.
DO NOT CUT THE WIRE THAT WILL SHUT
DOWN THE VEHICLE WHEN RUNNING BY THE KEY.
*
For Live Tech Support:
Call Certified Tracking Solutions at
1.780.391.3800
Toll-Free 1.855.287.4477
8AM - 5PM Monday to Friday MST
12V
ONLY!
QUICK INSTALL GUIDE
REV010517
AutoConnectGPS.com
THIS SIDE UP TOWARDS SKY
AutoConnectGPS.com
THIS SIDE UP TOWARDS SKY
For live Tech Support:
Toll Free
1.855.287.4477
Call Certified Tracking Solutions
8AM to 5PM
1.780.391.3800
Monday to Friday MST
