Auto-Trail Imala 615 2020, Owner'S Handbook Manual

Page: 30 / 70

29 Owners Handbook
Truma Combi 4E/6E
Vehicle Space Heater Truma Combi 4E/6E
Truma Combi 4E / Truma Combi 6E
The Combi E Gas Heater is a warm air heater with
an integrated hot water boiler. The unit can operate
on liquid gas (LPG) or 230V mains electricity.
The heater can be used in ‘Winter’ mode that
will produce warm air heating and hot water, and
‘summer’ mode that will produce hot water only.
Before operating the heater for the first time ensure
that the 12V system is turned ‘ON’ on the control
panel over the doorway, and that the gas cylinder,
and isolation valve are turned on. To use the heater
on 230V the Motorhome must be plugged into the
mains supply, with the isolation switch in the ‘ON’
position.
TRUMA CP PLUS CONTROL PANEL
1 = Display
2 = Status line
3 = Menu line (above)
4 = Menu line (below)
5 = Display of mains voltage 230 V (shore power)
6 = Display timer
7 = Settings / values
8 = Control knob / push
The control knob / push button (8) is used to
select menus in the lines (3 + 4) and configure the
settings. These are shown via a display (1) with a
lighted background. Pressing the Back button (9)
takes the user back out of the
menu again.
Control knob / push button
The control knob / push button (8) is used to select
and change set values and parameters; these can
be saved by clicking the control knob / push button.
Selected menu items will flash.
Back button
Pressing the Back button (9) takes the user back
out of the menu again and discards the settings.
This means that the previous values are retained.
Change the room temperature
• Use the control knob / push button to
select the symbol in menu line (3).
• Click to change to the setting level.
• Depending on the connected device, use the
control knob / push button to select between the
heater or air conditioning unit
(please note the air conditioning unit is not a
factory fitted option).
• Use the control knob / push button to select
the required temperature.
• Click the control knob / push button to confirm
the value.
Heater
Settable temperature range 5 - 30 °C (1 °C steps)
a = heater * – Heater is switched on.