9
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key
will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The
siren, horn, parking lights, and dome light will turn on to alerting of an intrusion for 30
seconds. Then it will stop and automatic reset and re-arm. If the one of sensors or
detectors still active, the alarm system will sound a maximum of 3 times of 30
second cycles.
NOISE ABATEMENT CIRCUIT:
Your system has “Noise Abatement Circuit”. It
prevents annoying repetitive trigger sequences due to faulty door pin switches or
environmental condition such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each
time, the same sensor or switch is triggering the alarm. “Noise Abatement Circuit” will
interpret this pattern of triggers as false alarm. After the third trigger, “Noise
Abatement Circuit” ignores, or bypasses, that sensor or switch until the other sensor
or switch is trigger. “Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If
the alarm is triggered by an open door for three full cycles, the doors will be bypassed
until the trigger ceases.
SYSTEM’S TRIGGER CHECK
(For two-way transceiver operation only)
Press the transceiver
button first, within 3 seconds press the
(C)
button. It responds with one melody sound and all
trigger’s records will immediately displayed on the LCD screen.
Note: If it has no responds then you are out of range.
Trunk/Hood Trigger
Doors Trigger
Shock Sensor Trigger
Ignition Trigger
Warn-away Trigger
CLEAR THE FLASH ICON AND MELODY SOUND:
While triggering
the alarm the LCD screen will alert user through melody sound and
flashing trigger icon, press the
button 3 times within 3 seconds
will clear the flash icon and stop melody sound on the LCD screen
transceiver.
STOP THE MELODY SOUND ONLY:
While triggering the alarm the
LCD screen will alert user through melody sound and flashing trigger
icon, press any button on the LCD remote transceiver to stop melody
sound only
