J1939 CAN bus Nodes Lost Warning
selects if the DCU should issue an event (J1939
Nodes Lost) when a J1939 node is lost on the network.
Erratic J1939 Data Warning Enabled
selects if erratic data on the SPN should generate a
sensor fault warning for that SPN.
J1939 CANbus Red Lamp Severity configures how the DM1 red lamp signal status is
handled by the DCU. The DCU can be configured to
Disabled
,
Alarm
, or
Shutdown
.
J1939 CAN bus Amber Warning Lamp Enabled
configures whether the DM1 amber lamp
should generate a warning or not.
RP Lost Warning Enabled
selects whether the DCU should issue a warning when a
connected RP is lost.
8.2.2 Suppress DM1 Fault
The ability to suppress combinations of SPN and FMI appearing on the J1939 interface.
home / dcu / miscellaneous / event configuration / suppress
dm1 faults
8.2.3 DM1 FMI Severity
Each FMI can be configured to either
Inactive
,
Maintenance
,
Warning
,
Alarm
, or
Load
Reduction
.
8.2.4 Output Event Configuration
home / dcu / miscellaneous / event configuration / output
event configuration
Latched Outputs For Threshold Events
selects whether the individual threshold events
(Warning High Event, Alarm High Event etc) used within the DCU should be latched or not.
Latched is defined as an active or unacknowledged event in the alarm list.
The common output events (for instance Event: 4-20mA #1) are always latched.
Page 80 (99)
