Authorized Alarms Controur, Operating Manual

Page: 8 / 12

8
Connection between IGLA and CONTOUR
Follow these steps to connect the devices:
1. Switch IGLA to the PIN-code change mode by one
of the following ways:
• connect the Grey wire from IGLA to Power supply
«+» and switch on the ignition;
• if the device is already connected, after the
authorization is successful enter the current PIN-
code once again while pressing the accelerator
pedal as far as it can go*.
ATTENTION! If you need to connect 2 and more
CONTOUR modules only PIN-code change mode
can be used (enter the PIN-code once again with
the accelerator pressed*). If the grey wire is used
while connecting to CONTOUR module all previously
connected to IGLA devices will stop functioning!
ATTENTION! For the connection of the second and
subsequent devices all previously connected devices
shall be disconnected from CAN-bus or power supply.
2. Connect the hood lock control module as
described above.
3. Apply power supply «+» to Grey and Red wires at
the same time.
4. The hood lock will open, close, and open again
within 5 seconds.
* For some car models other controls are used instead of an accelerator pedal
(see the annex to the IGLA operating manual).