7
Within 4 seconds after the
STOP button has been
pressed, press the START
pushbutton (or the selector)
then release it.
1
2
3
Page 11
FREQUENCIES
With the transmitter unit ON
(flashing green LED), press
the STOP button.
Working frequency change process
Turn the STOP button in the
direction indicated and repeat
the power on and starting
procedure.
WORKING FREQUENCIES
AUTOMATIC SCANNING MODE
The radio remote control is usually programmed by the manufacturer in this mode: it can
therefore work in any of the available frequencies. In cases of interference or conflict with
other systems, this mode makes it possible to move the working frequency (see the
process explained below) without having to intervene inside either the transmitting or the
receiving units.
Each working radio frequency to which a
radio remote control can be programmed
belongs to the set of frequencies permitted
by national standards that are valid at the
moment of entry into the market.
Each radio remote control is programmed by
the producer in the
AUTOMATIC
scanning or
MANUAL
selection mode.
!
The
use of
433.050÷434.790 Mhz
band frequencies
has not yet been
harmonised in Europe:
check for possible
user’s country
limitations.
MANUAL SELECTION MODE
A radio remote control operating in
MANUAL
selection mode can operate at a specific
frequency.
In order to set the frequency selected the dip switch on the transmitter and receiver units
must be set.
To activate this means of operation contact authorised Autec personnel.
N.B.: During the work frequency
changing process, the receiving
u n i t l o s e s r a d i o e l e c t r i c
connection with the transmitting
unit. After starting, some
seconds may be necessary to
reset connection,
therefore
k e e p t h e S T A R T b u t t o n
p r e s s e d f o r a b o u t 8 ÷ 1 0
seconds
.
E
N
G
L
IS
H
LIE16MU1
