AUSUM ML-CS37-36, Assembly, Use, Maintenance Manual, Page: 8 / 12

FR
ES
PT
IT
EL
PL
RU
UA
RO
EN
7 、 ASSEMBLY
Adjustable handle
This machine can be used as straight grip or pistol grip. Push adjust handle lock switch and hold to rotate the handle to the desired position. Release
the adjust handle lock switch, and then you can use the tool.
To charge the tool
The tool must be charged prior to the fi rst start-up.
1.Connect the USB cable to the charging socket.
2.Connect the other end of USB cable to the computer’s USB port or a USB charger on a wall socket(sold separately or the other telephone adaptor which
output current less than 2.1A)
3a. If the USB cable connected on the tool, during charging, the LED display of the tool shows red light. When it shows green light, the charging is ready.
3b. If the USB cable connected on the base, the LED display of the base shows green and
fl ashing in order, When it shows all green light, the charging is ready.
4.This screwdriver has integrated over-charged protection, when the battery cell is over-charge protection will operate to stop charge battery.
5.The battery is fully charged after 3-5 hours charging.
6.During the charging procedure, the handle of the machine warms up, this is normal.
7.After charging is
fi nished, disconnect the USB cable
NOTE:
If the tool is hot, allow it to cool to ambient temperature before charging. To prevent damage to the battery, charge the battery to at least a half-charge before
storing. If the tool will not be used for long periods of time, charge the tool every 3-6 months.
Change the bit
Inserting bits-Insert the screwdriver bit directly into the hexagon collects, it will be held automatically by the suction
Removing bits-Pull out fi rmly the screw driver bit
Note:
Do not use double-sided screwdriver bits that are longer than 25mm.
LED light
The screwdriver has a built-in LED light to illuminate the work area and improve vision when working in areas with insu ffi cient light. The LED light will be
automatically turns on while depressing the trigger switch.
8 、 USE
ON/OFF switch trigger
To start the tool, press the ON/OFF switch and keep it depressed. To switch o ff the tool, released the ON/OFF switch.
Forward/reverse switch
The forward/reverse switch is used to reverse the rotational direction of the tool.
Push the forward/reverse switch lever right to the stop(for screwing-in screws)
Push the rotational direction switch left to the stop(loosening or unscrewing screws).)
Torch’s ON/OFF switch
ON
There is a torch in the end of the machine.
OFF The torch produces a light beam that emerges from the lamp head.
To start the torch, push the switch to “on” position.
To turn o
ff , push the switch to “o ff ” position.
5