Austroflamm Clou Compact Pellet, User Instructions

Page: 23 / 48

Clou Pellet / Clou Compact Pellet User instruction 21 English
Safety temperature limiter
Your stove is equipped with a safety temperature limiter on the back. This auto-
matically switches off the stove if the auger shaft overheats. Should this happen,
the cause of the overheating must be determined and remedied. Afterwards, the
stove can be made ready for operation again by pressing the green reset pin in
the safety temperature limiter. The green pin is located under a black cylindrical
protective cap, which must be unscrewed beforehand.
6 Replacing the internal controller battery
The control unit switches to internal battery power during a power failure or when disconnected from the
mains power supply. A STAND-BY BATTERY then supplies power to the internal clock and memory.
Please bear in mind: If the battery is flat, the control unit will function normally as long as it is connected to
the mains power supply. However, in the event of a power failure, the internal clock will stop, and the oper-
ating phase is not saved. When the power is restored, the clock is reset to 00:00 and the control unit leaves
your stove in the OFF phase.
Replacing the battery (recommendation: every 2 years):
1. The battery is located on the central control unit. To access the control unit, open the inspection lid
and remove the right-hand cladding on the side of the stove.
2. Then remove the black panel on the control unit by unscrewing 4 crosshead screws.
3. Remove the old storage battery from the retainer.
4. Insert the new battery, paying attention to the correct polarity.
5. Screw the panel of the control unit back on.
6. Refit the right-hand side cladding.
7. Close the inspection lid and screw it firmly back into place.
-
+
Button cell battery
CR2032
Safety temperature limiter with
detachable black protective
cap