WPBT
INSTALLATION AND OPERATION MANUAL
5
5
FRONT PANEL
INPUT SELECTOR
Switches the audio input between the
Bluetooth receiver and the 3.5mm
auxiliary input.
3.5MM AUXILIARY INPUT
A stereo 3.5mm line level auxiliary input.
Connect wired devices to this connector
and select the AUX input on the source
selector button.
PAIRING BUTTON
Press until the LED starts flashing which
indicates pairing mode entered.
When the device pairs to the WPBT the
PAIR LED will stay on.
If no device pairs, and the pairing timeout
is exceeded, the LED will turn off and the
device will enter a non-discoverable state.
(If required, the timeout can be disabled
in software).
BLUETOOTH MEDIA CONTROLS
These buttons will send commands to
the paired device, e.g. a mobile phone, to
modify volume, play/pause or skip tracks.
NOTE: It does NOT provide any controls for
the 3.5mm auxiliary input.
NOTE: Some devices disable volume
syncing. Consult your device manual how to
enable volume sync.
BROADCAST NAME LABEL
The Bluetooth broadcast name should be
applied here.
It informs end users the name of the
device they should connect to from their
remote device.
BALANCED AUDIO OUTPUTS
Stereo balanced 3.81mm euroblock
outputs. If mono output is required, it can
be configured using the Bluetooth control
software via the USB-C connector. Mono
is outputted on both LEFT and RIGHT.
RS485
Unused in standalone operation.
This is used for connection to compatible
Australian Monitor products for direct
control of the WPBT without requiring the
Bluetooth Control Software programming.
E.g. The ZONEMIX system.
POWER INPUT
A15VDC (50mA) to
+24VDC(60mA) input.
USB-C CONNECTOR
Used to program the WPBT via the PC
control software.
1
2
3
4
5
6
7
8
9
1
3
8
9
7
2
6
4
4