I N T E R N A L A D J U S T M E N T S
PA G E 6
M X 8 8 3 I N S TA L L AT I O N & O P E R AT I O N M A N U A L
CHANNEL DIRECT OUT PRE/POST FADER
The pre or post assignment of the direct output is set via this jumper. This
is used to make the Direct Outputs either pre or post channel fader volume.
Set to the Channel 1 side the Direct Output is post fader (i.e. the channel
fader volume affects the Direct Output). Set to the Channel 8 side the Direct
Output is pre fader. The default factory setting is pre fader.
CHANNEL 1 AND 2 HPF
Channels 1 and 2 have a 120Hz 24dB/octave high pass fi lter to remove
handling noise and fl oor rumble. The fi lter is active by default. The jumpers
are located at the back of the unit on the upper board near channels 1 and
2. Move the jumper toward channel 8 to bypass the fi lter.
CHANNEL 1 ROUTING
If channel 1 is being used as a priority input it can be routed so that the
master volume does not affect channel 1. The default factory setting is pre
master fader meaning the master volume affects channel 1 in the mix. The
switch is located near the master pots. Move the switch toward channel 1
to set channel 1 to post master fader.
HEADPHONE
ROUTING
The headphone level can be routed so that it is affected by the master
volume. The default factory setting is pre master fader meaning the master
volume does not affect the headphone volume. The switch is located just
behind the front panel near the master pot. Move the switch toward the
front to set the headphone to post master fader. The headphone can also
listen to the aux output. The headphone source switch is below the pre/
post switch. Move the switch toward the front to set it to aux. When set to
aux the headphone is always post fader.
OPTIONAL
MODULES
The MX883 can have installed:
- 2 VCA modules for left and right outputs
- Tone Generator module
- 2 Priority Muting modules for left and right outputs
See your local Australian Monitor dealer for more information.
1
2
3
4
5
2
5
5
5
3
1
4
