The AMPAV40 speaker is turned on from the mains switch at the rear of
the unit. Once activated, the remote control can then be used to operate
the speaker remotely including setting the speaker system to standby mode
when not in use.
1
ON
This command will turn the unit on when in standby mode. The power LED
will change from orange to red.
2
ST.BY
Pressing ST.BY places the speaker system into standby mode. The indicator
LED turns orange.
3
MUTE
Enables or disables the audio.
4
UNBAL INPUT, BAL INPUT, USB/MP3
These three buttons are used to select the required input; Unbalanced,
Balanced or USB port. You can change to the appropriate input by simply
pressing the associated button.
5
VOLUME, TREBLE, BASS
You can select and adjust the volume, bass and treble of the speaker set by
using these controls.
6
USB/MP3
These buttons allows you to control tracks that are stored on the USB stick
using the standard player commands; play, pause, forward and reverse tracks
(refer to section 4 of the manual under USB for more information).
PAGE 7
AMPAV40 INSTALLATION AND OPERATION MANUAL
REMOTE
4
2
1
3
5
6
