R E A R PA N E L
PA G E 5
A M C - M I X I N S TA L L AT I O N & O P E R AT I O N M A N U A L
2
1
1
3
4
5
CH
1-3
Each channel input section has two inputs:
XLR input - This is a balanced microphone input. It has an input
sensitivity of 1mV.
RCA input - This is an unbalanced line level input. It has an input
sensitivity of 500mV. The two RCA sockets are summed to mono
internally.
TAPE
OUTPUT
The TAPE output is on unbalanced RCA connectors. The output level is
150mV into 10kohm at rated output. The output is dual mono.
The TAPE output is not affected by the MASTER volume control or the
BASS and TREBLE controls. The TAPE output does not receive the tone
signal if the optional tone generator module is installed.
LINE
OUTPUT
The LINE output is on a balanced XLR connector. The output level is 1V
into 1k at rated output.
NOTE: When wiring the LINE output as unbalanced, Pin2
should be wired as hot and Pin1 should be wired as
ground/shield. Do not wire Pin3.
AC POWER SOCKET
This is a 5.5mm x 2.1mm barrel socket. It accepts 20V AC power from
the plug pack provided.
(OPTIONAL) TONE MODULE
These terminals are for use with an optional tone module
(not supplied).
1
2
3
4
5
